2021年9月16日 · The park/neutral position switch detects the shift lever position and sends a signal to the ECM. For safety, the park/neutral position switch detects the shift lever position so that the engine can be started only when the shift lever is in the P or N position.

Controls to restrict the 4th upshift or to provide appropriate engine braking by using the ECM to determine whether the vehicle is traveling on uphill or downhill. The ECM sends current to the solenoid valve S1 and/or S2 based on signals from each sensor and shifts the gear.

The 4-speed automatic gearbox Toyota U340 (U341) has been used since 2000 on FWD Toyota Avensis, Corolla etc. with engine capacity up to 2 liters.

U340E A/T REPAIR MANUAL (RM824E) AUTOMATIC TRANSAXLE ASSY (U34#E Series) OVERHAUL. 1. REMOVE SPEEDOMETER (ATM) SENSOR [ 83181E / 3505 ] 2. REMOVE SPEEDOMETER DRIVEN (ATM) GEAR SUB–ASSY [ 33403G / 3505 ] 3. REMOVE NEUTRAL START SWITCH ASSY [ 84540G / 3513 ] (a) Remove the nut, washer and control lever.

A U340E automatic transaxle is provided on the 1NZ-FE engine model, and a U441E automatic transaxle is provided on the 2NZ-FE engine model. A low-viscosity type automatic transmission fluid (Toyota Genuine ATF WS) is used for the U340E

U340E automatic transaxle is as shown in the following chart. Crankshaft Position Sensor NE Ignition Switch NSW Engine Coolant Temperature (ECT) Sensor THW ECM Throttle Position Sensor VTA1, VC Park/Neutral Position Switch Speed Sensor Skid Control ECU Combination Meter R, D, 2, L STA SPD Shift Solenoid Valve S1 S1 Shift Solenoid Valve S2 S2 ...

(a) Turn the ignition switch OFF. (b) Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3. (c) Turn the ignition switch ON and push the tester main switch ON. (d) Enter the following menus: DIAGNOSIS / ENHANCED OBD II. (e) Perform the reset memory procedure from the ENGINE menu. CAUTION: After performing the ...

2024年8月8日 · Buy TRANSPEED U340E Transmission Neutral Safety Switch 84540-0C010 for Toyota Tundra Sequoia: Neutral Safety - Amazon.com FREE DELIVERY possible on eligible purchases

SERVICE SPECIFICATIONS – U340E AUTOMATIC TRANSMISSION SS–23 SS TORQUE SPECIFICATIONS Automatic Transaxle Assembly Part tightened N*m kgf*cm ft.*lbf Park/neutral position switch assembly (for bolt) 5.4 55 48 in.*lbf Park/neutral position switch assembly (for nut) 6.9 70 61 in.*lbf Automatic transaxle housing x Engine block 30 301 22

The gearbox ATF pressure switch is intended for interaction with the ECU of the car by means of pressure received from the pump. If the filter in the oil pan gets clogged, the pump will produce lower flow, putting less pressure on the switch.